Format of Original
4 p.; 26 cm
The Journal of Prosthetic Dentistry
Original Item ID
This article describes a method of fabricating a custom total occlusal convergence angle sticker with photo editing software and label stickers. The custom total occlusal convergence angle sticker can help clinicians achieve an accurate degree of taper during axial wall reduction of tooth preparation.
Cho, Seok-Hwan and Nagy, William W., "Custom Total Occlusal Convergence Angle Sticker Fabrication" (2015). School of Dentistry Faculty Research and Publications. 145.
Accepted version. The Journal of Prosthetic Dentistry, Vol 114, No. 3 (September 2015): 335-338. DOI. © 2015 Editorial Council for the Journal of Prosthetic Dentistry. Published by Mosby, Inc. Used with permission.
NOTICE: this is the author’s version of a work that was accepted for publication in The Journal of Prosthetic Dentistry. Changes resulting from the publishing process, such as peer review, editing, corrections, structural formatting, and other quality control mechanisms may not be reflected in this document. Changes may have been made to this work since it was submitted for publication. A definitive version was subsequently published in he Journal of Prosthetic Dentistry, Vol 114, No. 3 (September 2015): 335-338. DOI